We at Parkflyers R/C believe the Gee Bee 3D is the most fun to fly plane ever released. To prove this we want everyone of our customers to buy one !!! Now available at $189.99 its price to fun factor ratio cannot be beat and is priced to fly off the shelves. Get yours quick before promotion runs its course. Gee Bee 3D is our Ready to Fly brushless powered Airplane that can fly anywhere, even in your front yard! Will fly slow enough to fly in small confined backyards and has enough power to pull straight up to avoid your house!!! Guaranteed the most fun youll have flying an electric rc plane! The CEO of Parkflyers.com personally flies his Gee Bee 3D at his home for fun and is the perfect after work stress reliever for anyone.
The new Gee-Bee 3D can take RTF to a whole new level of fun. The highest power to weight ratio of any plane we carry. Gee Bee makes the perfect 3D flight trainer because of its low weight and stable flight. We had the Gee Bee 3D doing knife edge 6 feet off the ground within minutes of practice. Comes with a powerful outrunner brushless motor pre installed and a 2 cell 1800 Li-poly battery for 20 minute flight times. Can hover at a full 90 degree angle with ease. Very durable due to its light weight and carbon fiber rods that strengthen wing and fuselage. Complete 4 channel control with a super low 13.2 ounce flight weight allows user to perform any maneuver in the book. Features our new lightweight micro-receiver with 5000 foot range.
Large hinged tail surface allows for complex and precise 3D maneuvers.
Servos are placed close to both control surfaces to allow quicker crisper servo response needed for 3D Flight.
Landing gear secured by thin plywood for extra durability.
Included in one box : 4 Channel 2 stick Dual Spectrum 2.4GHZ Radio, NEW! 6 Channel 2.4 GHZ Receiver, 9 gram micro servos (3pcs), 1800 mah 2 cell 7.4 volt Li-poly battery, 90 minute peak charger, Brushless motor, 18 amp speed control and 10x4.7 Propeller. ARTF does not include Radio or Receiver.
RCU Video Review.This new video shows just how much fun one can have with the Gee Bee 3D.
Hover HQThe Gee Bee 3D is shown here hovering at a 90 Degree angle. The plane was flown 10-15 mph winds so keeping the plane steady was a challenge. To keep a plane steady in a hover takes steady hand and constant manipulation of all the controls. You always have to react before the plane does, however wind will add to the complexity of that challenge.
Hover2 HQShows Gee Bee in close at hover with completely hung on prop at 90 degrees!
